Connecting Turners Across the Globe
Articles that came from Newsletters
As shown during the July 3rd meeting of World Wide Woodturners, here is Paul Hannaby’s Morse Taper stand. The stand can be free standing or could be mounted flat on a wall if the protruding corner at the top left was cut off. My version was intended to hang on the end of a cabinet. Read More …
I started with a piece of laminated plywood from an old cabinet. It was only slightly larger than the round piece in the photos. I took a 1-1/2″ x 5″ block of oak and turned it round, making sure both faces were flat and parallel. Then I drilled a 21/32″ hole in the center of Read More …
Photos Courtesy of the Channel Island Woodturners of Ventura, Calif. This project is best for those who are experienced making platters and bowls. This platter will be between 15-17 inches in diameter, with a shallow bowl shape from rim to center that is deep textured using a mini power carver. The center will have a Read More …
Sometimes when you want to, need to, or are asked to do a turning that is beyond the capacity of your lathe. 99.99 % of the time, the answer, for safety’s sake, should be “NO”. When I was asked if I could turn some 36 inch long legs for a Kitchen Island. This exceeded the Read More …
The first step to getting a great finish on your turned vessel begins with the finish off the gouge and skew. Tool marks, tearout, and excessive sanding are a detriment to [any] great finish and must be avoided. Begin sanding at 220 grit and finish with 320/340 grit; sanding in an oscillating manner by hand. Read More …
Story and photos by Howard King Most of this process is based on work by Stuart Moritimer. Start with a 2″ by 2″ by 6″ piece of straight grain wood. Rough out the placement for the waist and the pointed tip. The section where the spiral columns will be carved should be a shape resembling Read More …
First you need a blank of wood about 6″ x 6″ x 1″ thick. Draw a heart or whatever shape you would like to have on a piece of 6″ x 6″ paper and cut it out for a template. Remember, long thin or pointed protrusions will be hard to turn and can break off. Read More …